■商品概要
【メーカー品番】280-914H
■詳細説明
HIGHSIDER AKRON-RS license plate holder
The HIGHSIDER AKRON-RS license plate holder adapts perfectly tothelines of your bike thanks to its design．
The model-specific bracket of the HIGHSIDER AKRON-RS allowsmountingon the original mounting points of your bike and thus areplacementwithout further drilling or cutting．
To prevent damage to cables， all sharp-edged feedthroughsareprotected by a rubber membrane grommet．
The license plate is made of sheet steel and 2 mm thick． Theprecisecutting is done by laser． After edging， theweather-resistant blackpowder coating is applied．
This ensures the optimal fit and durability．
Through the stepless adjustment you can bring the platewithoutdrilling in the desired position． To keep the plate inthisposition， there is an additional locking screw．
The turn signal brackets of the HIGHSIDER AKRON-RS are adjusdivinwidth and therefore suidiv for any type of accessory turnsignal．This adjustment option allows you to adapt the position foryourturn signals to the most varied number plates． To allowmounting theturn signals without disconnecting them from thewiring harness， the10 mm holes are slotted to the side．
You can also adjust the position of the reflector individually viaaslider． An adaptation to the different designs of the EUlicenseplates is therefore no problem．
To screw the license plate securely and reduce vibration， tworubberwashers are included． Another rubber buffer supports thelicenseplate on its underside．
Details:
- model-specific bracket
- infinitely adjusdiv turn signal holder
- slotted turn signal holder for easy mounting withoutcableseparation
- infinitely adjusdiv reflector， E-approved
- suidiv for European number plates
- infinitely adjusdiv tilt angle
- additional screw for optimum position security
- easy fixing without further work steps (e． g．B． Drilling)
- easy mounting of the license plate through slotted holes
Included in the scope of delivery of the HIGHSIDER AKRON-RSare:
- Model-related bracket with mounting parts
- HIGHSIDER AKRON-RS license plate retaining plate
- Adjusdiv turn signal brackets
- E-tested reflector with adjusdiv bracket
- Mounting instructions
Notes:
- If there are side reflectors fitted to your original numberplateholder， these must be refitted in a suidiv position orreplacedwith new ones．
- For the original turn signals the special turn signalholder280-970 is optionally available．
Tip:
If you have not found a model-specific license plate holder foryourvehicle， the universal license plate holders from HIGHSIDER，whichare available in many different designs， are certainly agoodalternative．
■注意点
※ナンバープレートサイズが日本の規格ではありませんので、取り付ける際にはステーによる加工などが必要なりますのでご注意下さい。
※輸入品のため、説明書が付属する場合、外国語の説明書となります。
※メーカー都合により商品の仕様変更がある場合がございます。ご了承ください。 ※画像はイメージです。
■適合車種
YZF-R125 (RE11)
YZF-R125 (RE11) 年式: 14-16
YZF-R125 ABS (RE11)
YZF-R125 ABS (RE11) 年式: 15-16
YZF-R125 ABS (RE29)
YZF-R125 ABS (RE29) 年式: 17-18
